First, go inside the car and get to the driver's side. At this point, disassemble the panel at the left end of the dashboard with your own hands. Once this is done, locate the OBD port located immediately behind and marked by the white color. When finished, put the protective panel back on. Posted on 16 December 2022 by ScegliAuto.
Location. North Herts. Apr 15, 2010. #6. You can see it by looking up from in the driver's side footwell. If you turn the fresh air / recirculate control to recirc, you can then see the resistor pack through the grille that recirc air passes through (if you can't identify this, have someone operate the recirc control for you as you look upwardsFiat Panda 169 1.2 Starter Motor Replacement. I replace the starter motor on my 2010 Fiat Panda 1.2 - the 60bhp model. Automobile Fiat Panda Owner's Handbook Manual. (206 pages) Car Receiver Fiat Idea Sound System Owner's Manual. The car sound system (34 pages) Car Stereo System Fiat Panda Owner's Manual. Sound system (22 pages) Automobile Electronics Fiat Panda Manual. Hands-free kit with voice recognition and bluetooth wireless technology (18 pages) Coolio, I bought a pump from some german manufacturer in end and a pre pump filter for an uno turbo (pump was for an unoT too, totally overkill really but better than nto enough fuel, thats what the pressure regulator is for) - the mk1 unoT's have an inline pump with a pre-filter as standard - i guess it was too early for in tank pumps back when the mk1 uno turbo came out.
this 7.5A fuse is more likely power both switches. its next to the OBDII connector. Dont assume the fuse will be 7.5A or F35 Fiat chop and change the wiring quite a bit. But it will be in this rough location..